Watlow MINICHEF Convection Oven Application Manuel d'utilisateur télécharger pdf (Page 26)

24 ■ Watlow MINICHEF 2000 Application 9

Auto-tuning Note:

Before auto-tuning Application 9, [teNp1] in the operations menu must first be set to a

value that is typical of your application. (See Hardware & Software Setup Guide for

information.) Then set [tHerl] / [tunE1] to [```on]. After you accept [```on], by

pressing “Enter,” the controller will display [`tunE] while auto-tuning is taking place.

The controller will cancel the auto-tuning process if it cannot be completed in 80 min-

utes. You can cancel the auto-tuning process at any time by pressing either key C or key

D and accepting [``Off], by pressing “Enter,” when it appears.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 39 40

Pas de commentaire

Watlow MINICHEF Convection Oven Application Manuel d'utilisateur Page 26