Watlow EZwarePlus Programming Manuel d'utilisateur télécharger pdf (Page 112)

104 EZwarePlus Programming Manual

Device tab settings:

1. Click the New… button. The Device Properties dialog appears.

 You can “export” a project created for one PLC brand to a different PLC brand by loading the

project file into EZwarePlus, then entering a different PLC type in this box. EZwarePlus will go through

your entire project and attempt to change each reference to PLC data registers to a logical selection

for the new PLC protocol; however, we strongly recommend that you review these changes to assure

that they are satisfactory.

2. Make sure the PLC button is selected.

3. There are two choices for Location – either Local or Remote. Select Local if the PLC will be connected

directly to the HMI. Select Remote if the PLC will be connected to a remote HMI via Ethernet. If

Remote is selected, then click the Settings button and configure the appropriate IP settings.

1010-1015, Rev. 03

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 263 264

Pas de commentaire

Watlow EZwarePlus Programming Manuel d'utilisateur Page 112