Watlow MINICHEF Deep Fat Fryer Application Manuel d'utilisateur télécharger pdf (Page 95)

Application 18 Watlow MiniChef 2000 ■ 93

Based on its programming, the unit will run the menu in one of the ways described

earlier.

Change Menus

1. With the controller in idle, select the menu you want to run by performing the pro-

cedure under “Select a Menu” earlier in this section.

2. Press the Start/Stop key.

Based on its programming, the unit will run the menu in one of the ways described

earlier.

Temperature Alarms

The controller will alert you to temperature alarm conditions if they occur. If an alarm

occurs, take action as determined by your supervisor. See the Appendix in the Hardware

& Software Setup Guide for a Troubleshooting Chart and a summary of temperature

alarms.

Errors

The controller will alert you to errors if they occur. Errors are critical problems that

shut down the unit. If an error occurs, an error message will appear on the display. You

should switch off the power and call for service.

See the Appendix in the Hardware & Software Setup Guide for a Troubleshooting Chart

and a summary of errors.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 110 111

Pas de commentaire

Watlow MINICHEF Deep Fat Fryer Application Manuel d'utilisateur Page 95